Maintenance method of automatic hot stamping&die cutting machine

Maintenance method of automatic hot stamping&die cutting machine:

1. Before operation, you should carefully read the manual of the automatic hot stamping&die cutting machine.

2. Before starting the machine, check whether the screws of each part are loose.

3. If abnormal conditions are found during use, the machine should be shut down for maintenance in time.

4. Always keep the machine clean, and regularly wipe the dust and surface dirt in the electrical box with a neutral detergent.

5. It is strictly forbidden for non-professionals to adjust the pressure of the pressure regulating valve or replace parts (referring to wearing parts).

6. After the work is completed and shut down, the power switch must be turned off before leaving; the power plug must be cut off when shutting down.

7. After each start-up, it must be run dry for 1-2 minutes before operation, so as not to burn out the motor and electrical components;

8. Do not directly touch the heating plate or metal objects with your hands when the machine is working to prevent burns;

Nine. Turn off the main power supply after the work is over before leaving the job, otherwise it will cause a fire;

10. When the machine is not used for a long time, the electric control part should be wiped clean and covered with a dust cover to prevent dust from entering and damaging the circuit board

11. Before going to work every day, the automatic hot stamping&die cutting machine should be cleaned once to keep the machine clean.